FREE GT-I9103 Repair Dead By USB Cable no need JTAG NO Need Disassembly Phone

FREE GT-I9103 Repair Dead By USB Cable no need JTAG NO Need Disassembly Phone

Download Links:http://forum.sptbox.net/GT-I9103_Dea...By_Xiaoyuz.rar

Password:forum.sptbox.net

how to enter APX mode:
hold "vol up"+"home" then connect usb cable to dead phone

after repair done phone will auto in download mode

full flash it by Odin all will ok

Enjoy free dead repair soft now

iPhone Check Warranty Unlock

iPhone iPad Check Warranty unlock function allows to check which network is the iPhone and check simlock status. This information is needed to order unlock service. Checking is done on the basis of the IMEI number. Information comes directly from Apple base.

After entering and checking the IMEI number, click Check Warranty Unlock (below the phone's data). A moment later we get the following data:

The network on Which the phone is locked
Serial number
Color / capacity
The warranty period
The current version of the software

GO-------

ACTION TAKEN: change LCD and make a jumper
Here:

Samsung Galaxy S i9000 JTAG pinouts

JTAG Repair on a Samsung Galaxy S i9000M

03acdd6f3e550725.jpg Nokia c3 Light Solution Only One jumper Apply

Nokia fake charging solution is here.Charge shows but never stored.No need to change tahvo ic just connect a 3.6 volt zenor diod between battery connector + and chargingconnector+. Output will be +.

44a0124d6c728ATR.jpg Hot Nokia fake charging solution 100% Tested........

Unit: Nokia 2330c
Fault: No Signal & Auto-Shut Off
Cause: Wet Unit
Solution for No Signal: Reheat UEM
Solution for Auto-Shut Off: Apply Auto-Shut Off Jumper Solution

Finished:

k530i volume key solution

D O N E . . .

1st move...clean the board by magic thinner..still the same!
2nd move... replace lcd..still the same!
kaya hanap na ako ng solution dito, papalitan ang coil...

may mga solution na nakapost dito pero wla screen shot kung saan nakuha ang pyesa na ipinalit, wla din ako same board para makunan ng coil na pamalit kaya isip mode muna...may mga china phone akong board na stock pero wla kaparehas na coil...dahil sa wala ako maipalit na coil, eto sinubukan ko, coil ng 1110i...

then jumper ko nalang kasi malaki sya compare sa orig na coil...

pagkatapos eto na assemble ko na, sasabit ang cover kaya eto medyo inangat ko..

pagkatapos eto na finish product...