Sunday 26 February 2012

Nokia C2-03, C2-06, C2-08 Not Charging Problem Solution

Now working on with the new solution for Nokia C2-03, C2-06 and C2-08 with Dual SIM phone capability. This time we will tackle first the charging circuit in case handling into troubleshooting a not charging problem, due to wet damaged or any possible causes.

The highlighted components below are the basic components of Nokia C2-03, C2-06 and C2-08 charging circuit just like any other Nokia previous PCB designs, the only thing always makes any different is the location of those particular components location being mounted on the PCB board.  


And here's how to fix a not charging problem for Nokia C2-03, C2-06 and C2-08
1) Ensure and check first the wall charger, battery and battery connectors for possible damaged. 
2) Check the charging pin connector (DC jack), clean it including the terminal contact pads. Replace if necessary.
3) Check the charger voltage protection components such as the fuse, diode, filter coil and capacitors. Replace if found damaged. 
4) Trace the charger voltage line paths for possible open circuit or cut-off lines. 
5) Check the charging voltage transistor switching circuits, including the 0.15 ohms fusible resistor. 


 
Nokia C2-02, C2-03, C2-06 Not Charging Problem Jumper ways
Nokia C2-03, C2-06, C2-08 Charging Problem Solution

1 comments:

Anonymous said...

Very descriptіve post, I liked that a lot. Will
there bе a part 2?

Alѕo viѕit my webpage: resіstor гesistance
()

Post a Comment

Please Do Not Spam.Our Blog.Spam Comments Will Be Removed Immediately